Pharmacy Equipments

Electronic Stimulator

Available in five models
1. Student Stimulators Transistorised : Out put 0-25 DC in two steps, duration .5 ro 1.5ms frequency 5 to 100 c/s in 11 steps, modes, single, repetitive or an external trigger, for 220V 50Hz.
2. Student Electronic Stimulator Latest Design :
• Frequency continuously variable from 0.1Hz to 100Hz in 3 decades of 0.1 to 1, 1 to 10 and 10 to 100 selectable through push-button controls and one continuously variable control.
• Output voltage continuously variable from 0 to 30V in two steps of 1 to 3 and 1 to 30, selectable through a switch.
• Fixed pulse duration 1m sec
• Single & external trig. single pulse facility
• Sensitive speaker to give audible indication or each output
• High stability new circuitry minimises external interference.
3. Stimulator General Purpose : Provides rectangular pulse of controlled amptitude 0.1 - 100V. Frequency 0.1 - 1000 PPS & width 0.01 to 100mm.
4. Research Stimulator With R.F. Isolation unit : Provides rectangular pulse of controlled polarity, Amptitude 1.5mV to 150V, frequency 0.1 to 10 KCS delay 10 micro sec to 1 sec & width 10 micro sec to 1 sec.

Dissolution Rate Test Equipment

The apparatus consists of 4 parts. A water bath with 500 watt heater covered 1000ml. Vessel made from Borosil Glass and digital temperature control. Variable speed motor, with 30 cms longs stainless steel shaft. A cylindrical stainless steel basket and a membrane fixing attachment, water bath is made of imported thick acrylic sheet with transparent cover at top. Temperature of the bath is maintained at 37°C with an accuracy of ±1°C. A cylindrical glass vessel of 1000ml capacity with slightly concave bottom has a flenged edge at the top to accept a fitted cover having four holes. One hole placed in the centre. The shaft of the motor is fitted on an up right and has an electronic speed regulating device that allows the speed to be varied from 25 to 250 RPM. The shaft is 6mm dia 30cms on with basket fitted at end rotates smoothly and without any significant wobble. The basket consists of two parts one of which is attached to the shaft. It is of solid metal except for 2mm vent and is screwed on the main shaft. Lower part of the basket is held with this part by means of threading and this allows proper removal of lower part for introduction of the test samples. The detachable part of the basket is fabricated of stainless steel mesh formed into cylinder of size 36mm x 25mm dia. The equipment is workable on 220 volts 50 C/s A.C.

Bicycle Ergograph

A bicycle frame is supported by a wooden stand, from the front of which two uprights ascend and carry a desk and cross piece, which provide for the attachment, directly in front of the subject, of the tension balances and other pieces in front of the subject, of the tension balances and other pieces of apparatus. A cast iron wheel of 5 1/2 feet in circumference, weighing 22 Kilos and mounted on ball bearing, is substituted for the back wheel. This wheel has slightly beveled edges and is turned true. To the circumference of this, a stout calico is applied, and the two ends of the band ate attached to spring balances of 6 lbs. range (Graduated in one oz.) calico-band to the balance pass round adjustable pulleys in order to give them the right direction. An adjustable record counter records the revolution of the wheel.

Karl Fischer Apparatus for Moisture Content Determination

1. Microprocessor K.F. moisture titrator with built in magnetic stirrer, auto computation of moisture in ppm, %age and mg H2O storage of date, time, batch no. & final results of 20 titrations. K.F. reagent dispensing by motorised process. Final results are flashed on 8 digit display. External printer attachment facility available.
2. Auto Karl Fischer Titrimeter (Deluxe Model) having seperate control and stirring units with array of 10 LED, buzzer auto zero burette, adjustable timer, dual platinum electrode and other accessories.
3. Auto Karl Fischer Titrimeter with seperate control and stirrer unit auto zero burette, dual platinum electrode & other accessories.

Soxhlet Extraction

1. Heater Mantle Type : Unit of three or six. Available in different capacities.
2. Hot Plate Type : Tis heater is used to heat soxhlet flasks and it consists of a mild steel housing. Unit of three or six. Three or six hot plates of dia 4 1/2" are mounted on top of the housing and can be operated by individual a) ON/OFF switch b) Rotary switch c) Energy regulator as per requirements. Mild steel housing has two rods with two adjustable cross rods on which the glass apparatus can be fixed. Electrically operated on 220 / 230 volts AC mains with max. power rating of 900 watts. The apparatus is supplied without glass parts.
3. Glass Parts : Complete with one flask and bulb condenser with interchangeable joints. Different capacities.

Incubators

Thermostatically controlled by thermostat ambient to 80°C with a sensitivity ±1°C. Beaded heating elements are placed in ribs at bottom and sides. Double walled inside aluminium or stainless steel and outside mild steel sheet painted with attractive enamel. Door has double glass viewing, built in horizontal L-shape thermometer with perforated adjustable shelves, two pilot lamps, ON/OFF switch. To work on 220/230 volts
A.C. Inner Chamber size Aluminium & S.S.
• 300 x 300 x 300mm (12"x12"x12")
• 350 x 350 x 350mm (14"x14"x14")
• 300 x 400 x 400mm (16" x 16" x 16")

Friability Test Apparatus

Used to determine the durability and abrasivness of tablets. A transparent perpex drum (made of imported perspex sheet 6.4 mm thick) 300mm dia x 35mm deep and white cover disc and nut, also a shaped radial fixed blade which carries the tablets along with it up to the central height and lets them off while the drum is rotating. Thus the tablets rub against each other without any hard impact. The drum rotates at a fixed speed of 30 RPM by a geared motor and the rotation period is controlled by a timer (imported time switch duration 1 to 15 minutes) per determined end preset. The motor unit is housed in a shaped steel cabinet with shaft extended on one side upon which the drum rotates. Switches with neon indicators and time switch are fitted on a panel and provided work on 220 volts 50C/s AC . Digital models also available.

Friability Test Apparatus

Used to determine the durability and abrasivness of tablets. A transparent perpex drum (made of imported perspex sheet 6.4mm thick ) 300mm dia x 35mm deep and white cover disc and nut, also a shaped radial fixed blade which carries the tablets along with it up to the central height and lets them off while the drum is rotating. Thus the tablets rub against each other without any hard impact. The drum rotates at a fixed speed of 30 RPM by a geared motor and the rotation period is controlled by a timer (imported time switch duration of 1 to 15 minutes) per determined end preset. The motor unit is housed in a shaped steel cabinet with shaft extended on one side upon which the drum rotates. Switches with neon indicators and time switch are fitted on a panel and provided work on 220 Volts 50 C/s AC. Digital models also available.

Operation Table Large Size

made entirely from stainless steel, in two halves slopping towards the centre a small wedge over the whole length separates the two halves, under the wedge provided a brass drain pipe. Removable and replaceable by sliding IN or OUT blood and other fluids flow towards the centre of the table, from where these drip into the drain pipe and carried through an end drain tube to the recepatable after operation the whole top can be washed clean the drain pipe removed, cleared and replaced the S.S. top is heated, a set of electric lamps placed to effect balanced heat distribution dog holder with its SS upright slide along slot in the top useful for fixing accessories. A S.S. swing tray is fitted on a upright in one corner of the top useful for placing dissecting instruments accessories etc. Steep pipe frame handle and wheels for conscience in moving. Table top size 51" x 18" x 40" high.

U.V. Inspection Cabinet Long Wave

1. U.V. Chromatography : Inspection cabinet for viewing and detecting separated substances on T.L.C. layers fitted with long wave (365nm) U.V. lamp for use on 220V A.C.
2. U.V. Chromatography : Inspection cabinet for viewing and detecting separating substances on T.L.C. layers fitted with two different wave length U.V. tubes for use on 220V A.C.
3. U.V. Inspection Cabinet (Short and Long Wave) Dual Wave : Having imported filters fitted with separate low pressure mercury vapour tubes for short U.V. (254nm) and long U.V. (365nm) plus separate lamp for visible light, the low pressure mercury vapour tubes in this model facilitate immediate use for inspection as you switch on.
4. Separate U.V. tube.

Motor Driven Disintegrator

Laboratory Size, hammer type with H.P. heavy duty motor (single phase) 220 volts, 50C/s A.C. consisting of four steel hammers fixed to a disc of 3" in dia 1" thick through which passes a shaft being revolved at 3000 RPM. The hammers are enclosed in a C.I. drum, the sides and upper surface of which are roughened in a C.I. drum, the sides and upper surface of which are roughned. The inner surface is undulating. The lower part of drum is made of chrome plated brass and is detachable so that SS sieves of different mesh size (a set of three sieves of coarse, medium & fine) supplied with the instrument can be easily placed. Hopper is made of die casted aluminium, built on angle iron frame of size 24" x 14" x 20" high.

Double Unit Organ Bath

A perspex organ bath with fine thermostatic temperature control, electric stirrer and complete set of accessories, making it a versatile unit for all research work. Bath 12"x9"x8", with leak proof dovetailed joints, resting in sturdy metal frame; top of the bath carries a 1"x3/8" thick band, for fixing accessories, inside the bath is a metal sheathed heating element (easily replaceable) controlled by means of a fine adjustable thermostat with sensitivity ±1°C. The stirrer unit is completely independent and dips in the bath in one corner, fixing on its special stainless steel upright. A M.S. junction box is fitted to the bath frame and carries all the electrical leads and connections, two pilot lamps indicate functioning of the thermostat and stirrer.

I.R. Moisture Balance

A basic method for determination of moisture content, measure percent by weighing and drying simultaneously. Infra red radiation are reflected by a bulb and its temperature is controlled by a regulator.
The balance scale is divided in terms of moisture content on wet weight basic.
Specifications :

Hot Air Sterlizer (Oven)

Double walled suitably insulated temp. control 50°C to 250°C ±1°C by E.G.O. thermostat inner chamber aluminium / stainless steel. Fitted with L shape thermometer. Available in Aluminium & S,S, in various sizes.
Inner chamber size :
• 12" x 12" x 12"
• 14" x 14" x 14"
• 16" x 16" x 16"
• 18" x 18" x 18"
• 24" x 18" x 18"
• 24" x 24" x 24"
• 36" x 24" x 18"

Hot Plates

Round 20cm (8") dia single operated
• Complete with three step rotary switch, plug & cord
• Same as above with double plates of 8" dia
• Hot plates rectangular electrically operated complete with 3 step switch with cord and plug.
• 300 x 250mm (12" x 10")
• 400 x 250mm (16" x 10")
• 450 x 300mm (18" x 12")
• 600 x 180mm (24" x 18")

Ball Mill Motor Driven

For mixing & grinding, electrically operated having capacity of few gms to 1 KG & 2 KG. Fitted with geared motor with max speed of 80 rpm. The jar is made of SS and having steel balls of different sizes to be put in jar for mixing & grinding pesticides power. Jar is interchangeable and easily removable, light in weight and compact unit working on 220 V AC with 1 KG cap.
-- do -- SS Drum 2 KG capacity
-- do -- Aluminium Drum 1 Kg Capacit
-- do -- Aluminium drum 2 KG capacity

Colony Counter

Digital Display, these are designed to provide light effects for multipurpose viewing in bacteriology, virology & Mycology labs. An ideal instrument for counting bacterial and mould colonies in culture work. It provides uniform flare free illumination to minimise the strain on eyes and clearly defines even small colonies. A 100mm dia lens covers the entire illuminations field and its magnification assures highly accurate results. Counting plate with standard wolfhugel ruling ensures clealy differentiated and sharply defined colonies. Supplied complete with counting plate, lens, cord and plug.

Rotary Vacuum Film Evaporator (Buchi Type)

This model of evaporator is supplied complete with A.C. non-sparking geared drive unit, support stand fitted with jack arrangement of stainless steel rod for positioning glass assembly, variable speed regulator, thermostatically controlled stainless steel water bath fitted on a jack, double coiled glass condenser with three opening for vacuum and cooling, pear shape evaporating flask capacity 800ml. receiver flask capacity one litre with ball joint, feeding tube and vapor path tube, a complete working unit. All parts are power coated with apoxy / polyster hybrid, textured, Siemens grey finish